Installation For Children 80-106 Lbs. (36¼-48 Kg); Lap Belt - Long Route - Dual Tether - R82 Wallaroo User Manual

INSTALLATION FOR CHILDREN 80-106 LBS. (36¼-48 kg)

Lap Belt - Long Route - Dual Tether

You must always use the top tether hooks when
installing this child restraint. Loosen the tether
strap and place it up and over the child restraint
back (A).
Place the child restraint in the forward facing
position on the vehicle seat. Ensure the bottom
of the child restraint shell is in full contact with
the vehicle seat.
Pull the vehicle belt out and route under the
child restraint cover, around front of seat shell
and through the belt slot furthest from the
vehicle buckle (B), from the front to the rear of
the child restraint.
Route the vehicle belt across the back of the
child restraint, continuing through the belt slot
closest to the vehicle buckle, from the rear to
the front of the child restraint shell. The vehicle
belt must be routed over the harness straps on
the rear of the child restraint.
Route the vehicle belt under the child restraint
cover, around to the outside of the seat shell
C
near the vehicle buckle (C).
Verify that the vehicle belt is not twisted and
then buckle.
Push the child restraint firmly into the vehicle
seat while removing slack from the vehicle belt.
Lock the vehicle belt according to the
instructions in your vehicle owner's manual.
Attach both tether hooks to the vehicle
designated tether anchors for the chosen
seating position (D). Remove all slack from the
tether to secure (E). Store any excess tether
strap webbing within your vehicle.
Verify that all connections are secure, the
vehicle belt is tight, and the child restraint is
secured.
The child restraint is secure when it cannot be
moved more than 1 inch (2.5cm) front to back
or side to side at the belt path. If the child
restraint is not secure, repeat this process or
use the alternate seating positon.
E
D
B
16
A
support.R82.org