Power Control - Pioneer PDP-LX508G Operating Instructions Manual

Setting up
5 Select "Sub Volume" (/).
6 Select the desired volume level (/).
7 Press HOME MENU to exit the menu.
Note
• To adjust the volume for headphones after selecting "Sub",
always use "Sub Volume" from the menu, whether the screen
is in single, 2-picture or picture-in-picture mode. When the
screen is in single mode with "Sub" selected, audio coming
from the screen is output from the speakers even with
headphones connected.

Power Control

Power Control provides convenient functions for power saving.
Energy Save
You may use one of the three Energy Save modes to save power
consumption.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "Energy Save" (/ then ENTER).
4 Select "Mode 1", "Mode 2", or "Picture Off" (/ then
ENTER).
Energy Save
Selections Off Provides normally bright pictures
Mode 1 Consumes less power than "Off" mode
Mode 2 Consumes less power than "Mode 1"
Picture Off Deactivates the screen to save power. To restore
the screen display, press any button other than
i + /i –,
This setting is not memorized by the system.
5 Press HOME MENU to exit the menu.
Note
• When you change the Energy Save mode, you may notice a
change in the panel sound. This is normal.
• The Energy Save function can maintain efficiency of the screen
for a long period of time. Setting the Energy Save function to
"Mode 1" is recommended in order to maintain efficiency of the
screen for a long period of time.
No Signal off (AV source only)
The system will be automatically placed into the standby mode if no
signal is received for 15 minutes.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "No Signal off" (/ then ENTER).
4 Select "Enable" (/ then ENTER).
No Signal off
Selections
5 Press HOME MENU to exit the menu.
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the plasma television after a TV
program finishes.
No Operation off (AV source only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "No Operation off" (/ then ENTER).
4 Select "Enable" (/ then ENTER).
(Sound Effect) or e.
No Operation off
Selections
5 Press HOME MENU to exit the menu.
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
Disable Does not place the system into the standby mode
(default)
Enable Places the system into the standby mode if no
signal is received for 15 minutes
Note
Disable Does not place the system into the standby mode
(default)
Enable Places the system into the standby mode if no
operation is performed for three hours
Note
08
35
En