Power Control; Energy Save; No Signal Off; No Operation Off - Pioneer PDP-428XDA Operating Instructions Manual

08 Setting up
5 Select "Sub Volume" (/).
6 Select the desired volume level (/).
Sound Effect
Headphone Output
Sub Volume
7 Press HOME MENU to exit the menu.
Note
• To adjust the volume for headphones after selecting "Sub",
always use "Sub Volume" from the menu, whether the screen
is in single, 2-screen or picture-in-picture mode. When the
screen is in single mode with "Sub" selected, audio coming
from the screen is output from the speakers even with
headphones connected.

Power Control

Power Control provides convenient functions for power saving.

Energy Save

You may use one of the three Energy Save modes to save power
consumption.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "Energy Save" (/ then ENTER).
4 Select "Mode1", "Mode2", or "Picture Off" (/ then
ENTER).
Energy Save
Selections Off
Mode1
Mode2
Picture Off
5 Press HOME MENU to exit the menu.
Note
• When you change the Energy Save mode, you may notice a
change in the panel sound. This is normal.
• The Energy Save function can maintain efficiency of the screen
for a long period of time. Setting the Energy Save function to
"Mode1" is recommended in order to maintain efficiency of the
screen for a long period of time.
36
En
Sub
15
Provides normally bright pictures
Consumes less power than "Off" mode
Consumes less power than "Mode1"
Deactivates the screen to save power. To
restore the screen display, press any button
other than i +/i –, h (Sound
Effect) or e.
This setting is not memorized by the system.
No Signal off (AV source only)
The system will be automatically placed into the standby mode if no
signal is received for 15 minutes.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "No Signal off" (/ then ENTER).
4 Select "Enable" (/ then ENTER).

No Signal off

Selections Disable Does not place the system into the standby
(default) mode
Enable Places the system into the standby mode if
no signal is received for 15 minutes
5 Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the plasma television after a TV
programme finishes.
No Operation off (AV source only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "No Operation off" (/ then ENTER).
4 Select "Enable" (/ then ENTER).

No Operation off

Selections Disable Does not place the system into the standby
(default) mode
Enable Places the system into the standby mode if
no operation is performed for three hours
5 Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby
mode, a message appears every minute.