Advertisement
MAIN HARNESS CONNECTIONS (CONTINUED)
24-PIN AND 2-PIN UPPER LEFT KICK PANEL PRE-
FIT CONNECTIONS
1. Locate the vehicle's 24-pin and 2-pin pre-fit
connections located in the upper left kick panel area.
These connectors are secured to the vehicle wiring
using breakaway tape. (FIGURE O)
2. When the 2-pin pre-fit connector is located, unplug
and discard the mating wire jumper.
3. Carefully route the remote start harness 24-pin and
2-pin connectors to the upper left kick panel area,
making sure that they will not interfere with any
vehicle moving components and re-assembly of
dashboard panels. (FIGURE P)
4. Plug the remote start harness 24-pin and 2-pin
males connectors into the corresponding 24-pin and
2-pin vehicle female connectors.
5. Using 2 of the supplied 8" tie wraps, secure the
remote start wiring to existing vehicle wiring.
6. Route the remote start harness programming button
and 30-AMP fuse assembly to the vehicles fuse box
assembly and secure the wiring to existing vehicle
wiring using one of the supplied 8" tie wraps.
(FIGURE Q). DO NOT SECURE THE REMOTE
START HARNESS TO ANY VEHICLE YELLOW
HARNESSES / CONNECTORS (AIRBAG SYSTEM).
PART NUMBER
H001SXA000
ISSUE
DATE
01
03/14/06
FIGURE O
FIGURE Q
SUBARU OF AMERICA
FIGURE P
5 OF 10
Advertisement
