Advertisement
WINDSHIELD MOUNT ANTENNA INSTALLATION (CONTINUED)
6. Route the antenna cable under the headliner
and down the A-pillar securing into the
plastic clips holding the sunroof drain tube.
Route the cable to the opening on the left
side of driver's dashboard. The antenna
cable will be plugged into the remote start
control module later. (FIGURE K)
7. Reinstall the A-pillar panel. Torque the 10mm
bolt to 10.8Nm +/- 2Nm (1.10 Kgf-m+/- 0.2
Kgf-m, 8 ft-lbs +/- 1.5 ft-lbs). (FIGURE J)
6
MAIN HARNESS CONNECTIONS
6-WAY IGNITION SWITCH CONNECTIONS
1. Locate the 6-pin ignition switch connector on the
left side of the steering column and unplug.
(FIGURE L)
2. Plug the remote start harness 6-pin female ignition
switch connector into the vehicle's ignition switch
and plug the previously unplugged vehicle's female
ignition switch connector into the remote start
harness 6-pin male ignition switch connector.
(FIGURE M)
3. Using 2 of the supplied 8" tie wraps, secure the
remote start harness wiring to the existing vehicle
wiring, making sure that it will not interfere with the
operation of the tilt steering column and re-
assembly of vehicle panels. (FIGURE N)
PART NUMBER
H001SXA000
ISSUE
DATE
01
03/14/06
FIGURE L
SUBARU OF AMERICA
FIGURE K
FIGURE M
FIGURE N
4 OF 10
Advertisement
