Pioneer PDP-428XDA Operating Instructions Manual page 3

IMPORTANT
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to alert
the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
CAUTION
The a switch on this unit will not completely shut off all power from the
AC outlet. Since the power cord serves as the main disconnect device
for the unit, you will need to unplug it from the AC outlet to shut down
all power. Therefore, make sure the unit has been installed so that the
power cord can be easily unplugged from the AC outlet in case of an
accident. To avoid fire hazard, the power cord should also be
unplugged from the AC outlet when left unused for a long period of
time (for example, when on vacation).
WARNING
This equipment is not waterproof. To prevent a fire
or shock hazard, do not place any container filled
with liquid near this equipment (such as a vase or
flower pot) or expose it to dripping, splashing, rain
or moisture.
WARNING
Before plugging in for the first time, read the following section carefully.
The voltage of the available power supply differs according
to country or region. Be sure that the power supply voltage
of the area where this unit will be used meets the required
voltage (e.g., 230 V or 120 V) written on the rear panel.
WARNING
This product equipped with a three-wire grounding
(earthed) plug - a plug that has a third (grounding) pin. This
plug only fits a grounding-type power outlet. If you are
unable to insert the plug into an outlet, contact a licensed
electrician to replace the outlet with a properly grounded
one. Do not defeat the safety purpose of the grounding
plug.
Operating Environment
Operating environment temperature and humidity:
+0 °C to +40 °C (+32 °F to +104 °F); less than 85 %RH
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or
strong artificial light)
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
The following symbols are found on labels
attached to the product. They alert the operators
and service personnel of this equipment to any
potentially dangerous conditions.
This symbol refers to a hazard or unsafe practice which
D3-4-2-2-2a_A_En
can result in personal injury or property damage.
This symbol refers to a hazard or unsafe practice which
can result in severe personal injury or death.
WARNING
To prevent a fire hazard, do not place any naked flame
D3-4-2-1-3_B_En
sources (such as a lighted candle) on the equipment.
VENTILATION CAUTION
When installing this unit, make sure to leave space around
the unit for ventilation to improve heat radiation. For the
minimum space required, see page 15.
D3-4-2-1-4_A_En
WARNING
Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of the product, and
to protect it from overheating. To prevent fire hazard, the
openings should never be blocked or covered with items
(such as newspapers, table-cloths, curtains) or by operating
the equipment on thick carpet or a bed.
STANDBY/ON Button
STANDBY:
D3-4-2-1-6_A_En
power flow is cut and the unit is no longer fully
operational.
STANDBY/ON Indicator:
the unit is in the standby mode and is lit blue when it is in
the power-on mode.
D3-4-2-1-7c_A_En
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
WARNING
CAUTION
When placed into the standby mode, the main
The indicator is lit red when
D3-4-2-1-1_En-A
D3-4-2-1-7a_A_En