Preparing The Remote Control Unit - Pioneer PDP-428XDA Operating Instructions Manual

05 Preparation
Tidying the speaker cables (PDP-508XDA only)
Use the supplied bead bands as necessary to tidy the speaker
cables.
Rear view
Note
• When tidying up your speaker cables, make sure to bundle
them so that they are not subjected to any pressure.
• Disconnect the power cord from the power outlet when the
plasma television is not going to be used for a long period of
time.
Connecting the power cord
PDP-508XDA (rear view)
MONITOR SUB
OUT WOOFER
DIGITAL DIGITAL
OUT OUT
OPTICAL OPTICAL
Power cord
Note
• Disconnect the power cord from the power outlet when the
plasma television is not going to be used for a long period of
time.
• After all other components are connected, connect the power
plug to the AC outlet.
18
En
Speaker cable
MONITOR SUB
OUT WOOFER
DIGITAL DIGITAL
OUT OUT
OPTICAL OPTICAL
Bead band
Noise filter
Partially eliminates noise
caused by the power source.
To power outlet

Preparing the remote control unit

Inserting batteries
1 Open the battery cover.
2 Load the supplied two AA size batteries while inserting
their respective negative polarity (–) ends first.
Place batteries with their terminals corresponding to the (+)
and (–) indicators in the battery compartment.
3 Close the battery cover.
Caution
Improper use of batteries can result in chemical leakage or an
explosion. Be sure to follow the instructions below.
• When you replace the batteries, use manganese or alkaline
ones.
• Place the batteries with their terminals corresponding to the
(+) and (–) indicators.
• Do not mix batteries of different types. Different types of
batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and new batteries
can shorten the life of new batteries or cause chemical leakage
in old batteries.
• Remove batteries as soon as they have worn out. Chemicals
that leak from batteries can cause a rash. If you find any
chemical leakage, wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter life
expectancy due to storage conditions.
• If you will not use the remote control unit for an extended
period of time, remove the batteries from it.
• WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY
WITH GOVERNMENTAL REGULATIONS OR
ENVIRONMENTAL PUBLIC INSTITUTION'S RULES THAT
APPLY IN YOUR COUNTRY/AREA.