Power Off - Pioneer DVR-540H-S Operating Instructions Manual

05
Recording
VCR Plus+ programming with the

power off

You can enter a PlusCode programming
number when the recorder is in standby.
Note that the recording is always made to
the HDD. If you want to record to a DVD disc,
you'll need to switch on the power and use
the full VCR Plus+ program screen.
Important
• You can't use this feature until you have
set up the guide channels. see VCR
Plus+ CH Setting on page 111.
• You can't change the recording mode.
• You can't program daily or weekly timer
recordings.
1 Press 'VCR Plus+'.
The front panel display shows the current
recording mode and prompts you to enter
the PlusCode programming number.
2 Use the number buttons to enter the
PlusCode number.
• To clear the last digit entered, press
CLEAR.
3 Press ENTER.
The display shows the timer settings:
Date Start time
Recording channel
• If CODE ERROR appears in the display,
check that the number is correct and
that the guide channel is set (see VCR
Plus+ CH Setting on page 111), then set
the timer recording again.
42
En
End time HDD and
Recording mode.
• If CAN'T SET appears in the display, it
means that although you entered a valid
PlusCode number, the program has
already finished.
Setting a manual timer recording
The timer recording screen you can see all
the timer programs already set, clear
programs and set up new ones.
1 Press HOME MENU, select Timer
Recording, then Timer Recording.
This screen shows all the timer programs
currently set.
Timer Program View
Manhattan Open Tennis
3/26 SUN 6:00PM – 7:00PM
World Journey
3/27 MON 7:30PM – 9:00PM
Flower
MON – FRI 1:30PM – 2:00PM
HDD Remain
DVD Remain
• Each row is for one timer recording
program, with the date and time
information, channel, recording mode,
DVD or HDD and recording status.
• The amount of free space available on
the HDD and the currently loaded
recordable DVD is shown towards the
bottom of the screen.
• In the upper-right corner, the number of
timer programs already set is shown
next to Tmr Pgms.
• If there are more than five timer
programs already set, press NEXT
to switch page (go back using the PREV
button).
• You can also delete a timer program
before it's started (before the recorder
enters timer recording standby) by
highlighting it and pressing CLEAR. See
3/26 SUN 3:00PM
Tmr Pgms 3/32
OK
10ch
OK
4ch
Until 4/20
8ch
New Input
59h59m(SP)
1h59m(SP)