Pioneer DVR-540H-S Operating Instructions Manual page 112

14
The Initial Setup menu
Setting
When recording dual mono audio to DVD in VR mode (except in LPCM mode), or to HDD with HDD Recording
Format set to Video Mode Off (except in LPCM mode), both audio channels are recorded and you can switch to the
one you want on playback.
Audio Out
Digital Out
When set to Off, all the following Audio Out settings are grayed out.
Dolby Digital Out
DTS Out
96 kHz PCM Out
MPEG Out
Audio DRC
Audio DRC is not effective when listening via the digital output when the Dolby Digital Out setting is set to Dolby
Digital.
112
En
Options Explanation
On •
Activates the digital audio output.
Off
Deactivates the digital audio output.
Dolby Digital • Output a Dolby Digital signal when a Dolby Digital
source is being played.
Dolby Digital Convert Dolby Digital sources to Linear PCM output.
PCM
Use if your connected equipment doesn't have a
Dolby Digital decoder.
On •
Output a DTS signal when a DTS source is being
played.
Off
Switch off the digital output when a DTS source is
being played. Use when your connected equipment
doesn't have a DTS decoder. In this case, use the ana-
log audio outputs.
96 kHz 48 kHz • Convert 96 kHz digital audio sources to 48 kHz out-
put. Use if your connected equipment doesn't sup-
port 96 kHz sampling rate.
96 kHz Output 96 kHz digital audio when a 96 kHz source is
being played.
MPEG Output an MPEG audio signal when a source using
MPEG audio is being played.
MPEG PCM • Convert sources with MPEG audio to Linear PCM out-
put. Use if your connected equipment doesn't have
an MPEG audio decoder.
On
Switches on Audio DRC (Dynamic Range Control).
Use when listening to Dolby Digital material at low
volume.
Off • Switches off Audio DRC.