SRAM Guide DB5 Service Manual page 33

C a l i p e r P i s t o n R e m o v a l
DOT fluid will damage painted surfaces. If any fluid comes in contact with a painted surface (i.e. your frame) or printing on the brakes,
wipe it off immediately and clean it with isopropyl alcohol or water. Damage to painted and/or printed surfaces by DOT fluid is not
covered under warranty.
Use an 8 mm line wrench to remove the crimped hose fitting.
1
Pull the brake hose and crimped hose fitting from the caliper hose
port.
Brake fluid will leak, so hold the caliper over a container to catch
the fluid.
2 Use a 5 mm hex wrench to remove the caliper body bolts.
Separate the caliper body halves.
3
Use a T10 TORX® wrench to remove the bleed screw.
4
N O T I C E
8 mm line wrench
5 mm hex wrench
T10 TORX wrench
Caliper Piston Removal 33