Pioneer DVR-230-S Operating Instructions Manual page 49

The Initial Setup menu
There are three different recorder IDs. When set to
Recorder2 or Recorder3, the remote control mode is
shown in the front panel display.
Remote Control
Remote Control
After selecting a new recorder ID, you have to confirm the
change by selecting Yes or No (use the
then pressing ENTER.
Remote Control
Remote Control
After changing this setting, the remote
control mode must be changed.
OK to Continue ?
Note that as soon as you change the recorder ID, the
remote becomes inoperative until you change the remote
to the same ID.
To set the remote, press and hold RETURN and a number
button (1, 2 or 3) for five seconds.
Setup Navigator
• Default setting: n/a
Basic
Basic Clock
Disc Tuner
Video OSD Language
Audio Display
Recording Remote Control
Playback Setup Navigator
Power Save
The Setup Navigator appears automatically when you
switch on the recorder for the first time (or after resetting
the recorder). It is also available from the Initial Settings
menu should you need it at any other time.
See also Switching on and setting up on page 18.
Recorder1
buttons),
Recorder2
Yes No
OSD Language
Tuner
Clock
Power Save
• Default setting: Off
Basic
Basic Clock
Disc Tuner
Video OSD Language
Audio Display
Recording Remote Control
Playback Setup Navigator
Power Save
Power Save
Power Save
When set to Off, signals arriving at the ANTENNA IN
terminal are passed through to the ANTENNA OUT
terminal when the recorder is in standby.
• On – No through function for the antenna terminal
• Off – Through function for the antenna terminal
Off
08
49
En