JVC RX-8010RBK Service Manual page 7

Removing the power transformer
Prior to performing the following procedures, remove
the top cover.
1. Unsolder the two harnesses connected to the power
transformer.
2. Disconnect the harness from connector CN55 and
CN56 on the power transformer board.
3. Remove the four screws M attaching the power
transformer.
Removing the power / fuse board
Prior to performing the following procedure, remove
the top cover and the rear panel.
1. Remove the screw N attaching the power / fuse
board.
2. Unsolder the power cord and other harnesses
connected to the power / fuse board.
Removing the power supply board
Prior to performing the following procedure, remove
the top cover and the front panel.
1. Remove the screws b fixing a bonding ground.
2. Remove the one nut attaching the headphone jack of
the power supply board on the front side of the body.
3. Disconnect the card wire from connector CN402 on
the power supply board.
4. Remove the three screws O attaching the power
supply board and pull out the power supply board
from the front bracket backward.
5. Unsolder the three harnesses connected to the
power supply board.
(See Fig.17)
(See Fig.17)
(See Fig.18 and 19)
Power
transformer
board
CN55/
CN56
Solder
Power cord
Fig.17
Power
supply
board
Fig.18
Power supply
O
CN402
Hook
Fig.19
RX-8010RBK/ RX-8012RSL
Power
supply
board
M
Power
transformer
M
N
Solder
Power / fuse board
b
Headphone jack
Nut
Headphone jack
board
O
Tie band
O
Tie band
Solder
1-7