Table of Contents
Advertisement
PROBLEM
"OVERLOAD" starts flashing on the
display.
The STANDBY lamp lights up after
turning on the power, but soon the
receiver turns off again (into standby
mode).
Remote control does not work.
Remote control does not work intendedly.
POSSIBLE CAUSE
Speakers are overloaded because of high
volume.
Speakers are overloaded because of short
circuit of speaker terminals.
The receiver is overloaded because of a
high voltage.
There is an obstruction in front of the
remote sensor on the receiver.
Batteries are weak.
An incorrect remote control operation
mode is selected.
SOLUTION
1. Press STANDBY/ON
on the front
panel to turn off the receiver.
2. Stop the playback source.
3. Turn on the receiver again, and adjust the
volume.
Press STANDBY/ON
on the front panel,
then check the speaker wiring.
If "OVERLOAD" does not disappear, unplug
the AC power cord, then plug it back again.
If speaker wiring is not short-circuited, contact
your dealer.
Press STANDBY/ON
on the front panel
to turn off the receiver. After unplugging the
AC power cord, consult your dealer.
Remove the obstruction.
Replace batteries. (See page 10.)
Select the correct remote control operation
mode. (See page 51 – 56.)
58
Hide quick links:
Advertisement
Table of Contents
