Brocade Communications Systems VDX 8770-4 Hardware Installation Manual page 66

NOTE
For rails with round holes, use the clip nuts (see
screws. For rails with square holes, use the retainer nuts (see
figure.
FIGURE 38 Using clip nuts and retainer nuts to secure screws to rack rails
4. Remove any existing rack-mount brackets from the device, and install the new Telco mid-mount brackets from the rack kit. See
the following figure.
66
1. Clip nuts (for rails with round holes)
2. Retainer nuts (for rails with square holes)
3. Rail
Figure 34 on page 62) on the rack rails for securing 10-32
Figure 34 on page 62). Also refer the following
Mounting the Device
Brocade VDX 8770-4 Hardware Installation Guide
53-1002563-10