Select Approach - Garmin GPSMAP 296 Pilot's Manual

Select Approach

NOTE: The approaches provided in the Jeppesen database are for monitoring purposes only.
The GPSMAP 296 is not an IFR-approved instrument and should not be used as a primary
source of navigation guidance in instrument conditions.
The 'Select Approach' option replaces a destination airport with the sequence of waypoints for the se-
lected approach. Keep in mind that the airport must have a published approach (GPS, RNAV, VOR, NDB,
localizer, or ILS) and only the fi nal course segment (usually from fi nal approach fi x to missed approach
point) of the published approach is available in the GPSMAP 296.
To select and navigate an approach for the destination airport:
1. Press the DIRECT TO D key to display the Go To Page.
2. Press to open the Options Menu. Highlight 'Select Approach' and press
MENU
3. Use the Arrow Keypad to select the approach from the pop-up window and press
4. A 'Vectors?' pop-up window appears. See the following page for more information on vectors-to-fi nal.
Use the ARROW KEYPAD to select 'Yes' or 'No' and press
the destination airport from the 'Go To' and replaces it with the approach waypoints.
NOTE: When using a route, and on the fi nal leg of the route to the destination airport, the
'Select Approach' option allows you to quickly retrieve and select available approaches. This
option overrides your current route. The original route is still available for later use.
To cancel the vectors and/or approach:
1. Press the D key to display the Go To Page.
DIRECT TO
2. Press MENU to open the Options Menu.
3. Highlight 'Cancel Vectors' and press
Highlight 'Cancel Approach' and press
ENTER/MARK
to navigate directly to the FAF.
ENTER/MARK
to cancel the entire approach.
ENTER/MARK
.
ENTER/MARK
ENTER/MARK .
. The GPSMAP 296 removes
Basic Operation
Navigating in
Aviation Mode
Go To Page Options Menu
Go To Page
Selecting an Approach from the Approach pop-up window
19