Low Band Transmitter Power Amplifier (Pa) 25-60 W; Power Controlled Stage; Driver Stage - Motorola 6864115B62-C Detailed Service Manual

Low Band Transmitter Power Amplifier (PA) 25-60 W

the AGC input pin 5 of U1601, reducing its gain and therefore the amount of noise pulses which are
detected and processed.
3.0 Low Band Transmitter Power Amplifier (PA) 25-60 W
The radio's 60 W PA is a three-stage amplifier used to amplify the output from the VCO to the radio
transmit level. The line-up consists of three stages which utilize LDMOS technology. The first stage
is pre-driver (U1401) that is controlled by pin 4 of PCIC (U1503) via Q1504 and Q1505
(CNTLVLTG). It is followed by driver stage Q1401, and final stage utilizing two devices (Q1402 and
Q1403) connected in parallel. Q1402 and Q1403 are in direct contact with the heat sink.
To prevent damage to the final stage devices, a safety switch has been installed to prevent the
transmitter from being keyed with the cover removed.
TXINJ
From VCO
Controlled
DC AMP
SPI Bus
3.1

Power Controlled Stage

The first stage (U1401) is a 20dB gain integrated circuit containing two LDMOS FET amplifier
stages. It amplifies the RF signal from the VCO (TXINJ). The output power of stage U1401 is
controlled by a DC voltage applied to pin 1 from the power control circuit (U1503 pin 4, with
transistors Q1504-5 providing current gain and level-shifting). The control voltage simultaneously
varies the bias of two FET stages within U1401. This biasing point determines the overall gain of
U1401 and therefore its output drive level to Q1401, which in turn controls the output power of the
PA.
3.2

Driver Stage

The next stage is an LDMOS device (Q1401) providing a gain of 13dB. This device requires a
positive gate bias and a quiescent current flow for proper operation. The voltage of the line
Power
PA
Driver
Stage
BIAS
Current
Sense
24
4
PCIC
INT
Figure 2-2 LowBand Transmitter Block Diagram
Pin Diode
Antenna
Switch
PA-Final
Stage
Current
Sense
PASUPLVLTG
29
Temperature
Sense
To Microprocessor
Power Adjust
Antenna
Harmonic
Filter
RF Jack
BIAS
(2 Lines)
5
6
ASFIC_CMP
2-5