Receiver Back End; Uhf Transmitter Power Amplifier (403-440 Mhz); First Power Controller Stage - Motorola CM160 Service Information

Commercial series cm radios uhf1 (403-440mhz) high power
Hide thumbs Also See for CM160:
Table of Contents

Advertisement

2-2
2.2

Receiver Back End

The IF signal from the crystal filter enters the IF amplifier which provides 20 dB of gain and feeds
the IF IC at pin 1. The first IF signal at 44.85 MHz mixes with the second local oscillator (LO) at
44.395 MHz to produce the second IF at 455 kHz. The second LO uses the external crystal Y301.
The second IF signal is amplified and filtered by two external ceramic filters (FL303/FL302 for
12.5KHz channel spacing and FL304/FL301 for 25KHz channel spacing). The IF IC demodulates
the signal by means of a quadrature detector and feeds the detected audio (via pin 7) to the audio
processing circuits. At IF IC pin 5, an RSSI signal is available with a dynamic range of 70 dB.
3.0

UHF Transmitter Power Amplifier (403-440 MHz)

The radio's 40W PA is a three-stage amplifier used to amplify the output from the VCOBIC to the
radio transmit level. All three stages utilize LDMOS technology. The gain of the first stage (U101) is
adjustable and controlled by pin 7 of U103-2 via U103-3. It is followed by an LDMOS stage Q105
and LDMOS final stage Q100.
From VCO
Controlled
Stage
Devices U101, Q105 and Q100 are surface mounted. Q100 is screwed down to the chassis to
ensure good thermal contact. This scheme also ensures sufficient thermal contact between driver
and chassis.
3.1

First Power Controller Stage

The first stage (U101) is a 24dB gain integrated circuit containing two LDMOS FET amplifier stages.
It amplifies the RF signal from the VCO (TX_INJ). The output power of stage U101 is controlled by a
DC voltage applied to pin 1 from the op-amp U103-3, pin 8. The control voltage simultaneously
varies the bias of two FET stages within U101. This biasing point determines the overall gain of
U101 and therefore its output drive level to Q105, which in turn controls the output power of the
PA
PA-Final
Driver
Stage
Bias
A S FI C _C M P
SPI BUS
C ont r ol le r
U 103 - 2
Figure 2-2 UHF Transmitter Block Diagram
Pin Diode
Antenna
Switch
Coupler
Forward
PA
PWR
SET
L oo p
THEORY OF OPERATION
Antenna
Harmonic
Filter
RF Jack
Temperature
Sense

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cm140

Table of Contents