Mounting The Cable Cubby - Extron electronics Cable Cubby 600 User Manual

im Vertrieb von
3. Install a second stand-off, in accordance with steps 1 and 2.
4. Slide the stand-offs back and forth in the horizontal slots to
position them so that the cables easily rise and lower but
do not fall below the stand-offs.
5. Tighten the Phillips head screws to lock the stand-offs into
position.
6. Install and position the third stand-off, in accordance with
steps 1 and 2 and 4 and 5 to secure the remaining cables.
Mountng the Cable Cubby
W
C
1. Cable Cubby 300, 600, and 800 — If
screw clamps are installed, remove them
from both sides of the enclosure
(figure 2-7 on page 2-12).
N
2. Remove the plastic strips that protect the corners of the
enclosure and the plastic film on the finished surfaces. If
a sticky residue remains, remove it with an appropriate
metal cleaning product.
C
www.camboard.de
CAMBOARD Electronics
The flanged edges of the top of the surface enclosure
are sharp. Exercise caution when the cubby is not
installed in a table to prevent personal injury.
The flanged edges of the top of the cubby are
bevelled to an ultra-fine thickness of less than
0.04 (4/100)" (approximately 1 mm). These
edges are soft and can be easily nicked or bent.
Exercise caution when handling and mounting the
enclosure. Mishandling can damage the appearance
of the enclosure.
Figure 2-7 shows the installation of
a Cable Cubby 300C. Cable Cubby
300S, 600, and 800 installations are similar.
Do not use isopropyl alcohol or other solvents to
clean the Cable Cubby. Strong solvents will ruin
some finishes.
Tel. 07131 911201 ce-info@camboard.de
Cable Cubby
Fax 07131 911203
Products • Installation
®
2-11