Preparing The Table With A Hole Saw; (Cable Cubby 300C Only) - Extron electronics Cable Cubby 600 User Manual

im Vertrieb von
Installaton, cont'd
Preparng the table wth a hole saw

(Cable Cubby 300C only)

Prepare the table with a hole saw as follows:
1.
W
2.
C
Figure 2-3 — Cutting the opening with a hole saw
www.camboard.de
Cable Cubby
2-6
CAMBOARD Electronics
On the tabletop or other installation surface, mark the 6"
circle, then find and mark the center of the circle.
Wear safety glasses when operating the drill.
Failure to comply can result in eye injury.
Using a portable drill with a 6" (or 152 mm) hole saw,
carefully cut the opening in the table surface at the
desired location (figure 2-3). Extron is not responsible for
improperly positioned Cable Cubbies.
Use a portable drill with sufficient power to handle
the 6" hole saw. Exercise caution when handling
the drill and hole saw. Take care to protect the
mounting surface from damage.
Tel. 07131 911201
Products • Installation
®
Fax 07131 911203
ce-info@camboard.de