Catalog Number Explanation; Before You Begin; Remove The Grounding Screw In Select Power Configurations - Allen-Bradley Kinetix 5700 Installation Instructions Manual

Catalog Number Explanation

This publication applies to the following Kinetix 5700 DC-bus power supplies.
DC-bus Power Supply Catalog Numbers
DC-bus Power Supply
Cat. No.
2198-P031
2198-P070
2198-P141
2198-P208

Before You Begin

Remove all packing material, wedges, and braces from within and around the components. After
unpacking, check the item nameplate catalog number against the purchase order.
Parts List
The DC-bus power supplies ship with the following:
•
DC-bus end caps
•
Wiring plug connector set for mains input power (IPD), 24V control input power (CP),
digital inputs (IOD), shunt power (RC), and contactor enable (CED)
•
Wiring plug connector for shunt power (RC) connections installed on the drive
•
These installation instructions, publication 2198-IN009
TIP

Remove the Grounding Screw in Select Power Configurations

Remove the grounding screw when using ungrounded, corner-grounded, and
impedance-grounded power configurations.
IMPORTANT
Module
Width
Input Voltage
mm
55
324...528V rms,
three-phase
85
Replacement connector sets are also available. See the Kinetix Servo Drives Specifications
Technical Data, publication GMC-TD003, for more information.
If you have grounded-wye power distribution, you do not need to remove the screw. Go to
Install the DC-bus Power Supply on
EMC performance can be affected if you remove the grounding screw.
Continuous
Output Power
kW
7
17
31
46
page 5.
Rockwell Automation Publication 2198-IN009B-EN-P - June 2015
Kinetix 5700 DC-bus Power Supplies 3
Continuous
Output Current
A rms
DC
10.5
25.5
46.9
69.2