Basic Operation; Switch „On" The Settop; Standby Mode - Allied Telesis AT003-HDR Manual

2. Basic Operation

2.1 Switch „ON‟ the Settop
First, plug in your Settop. Next, set the Power ON/OFF switch on the rear
panel of the Settop to „ON‟. Then, press the [Power] button on the front panel
or remote control, to turn the Settop ON. When the Settop is first used, it will
start a „First Time Setup‟ walk-thru operation.
? Frequently Asked Question
Q: My Settop is powered on, but the TV screen shows nothing:
A: Make sure your TV is set to the correct video input. For example, if you
have connected the Settop to the HDMI1 input of your TV, then you need to
select the corresponding input of the TV.
Q: My Settop is powered on, but only a "No Signal" display is shown.
A: The channel you selected has no signal. This can be caused by
several reasons:
1. The channel you selected currently has no programming from your cable
provider. Select another channel.
2. The signal of the current TV channel is too weak. You can try changing to
another channel with a stronger signal. If the problem still exists, please
consult your local Cable TV Provider.

2.2 Standby Mode

1. Press the [Power] button on the front panel or remote control, to switch from
operational mode [ON] to standby mode [OFF].
2. In standby mode, press the [Power] button on the front panel or remote
control, to switch to operational mode [ON]. The last active channel will be
tuned and displayed.
3. To switch the Settop off completely, set the Power ON/OFF button on the
Rear Panel to [OFF]. Or, you may unplug the main power cord from the AC
wall outlet.
7
Menu Operations