Installation Information; Accessories - impro IXP20 Installation Manual

Display (ISC921 Only)
Type ...............................
Resolution.......................
Colour .............................
Back-lighting ...................
Status LED
Power On........................
Upgrade Mode ................
Incoming RS485 Data ............
Outgoing RS485 Data ............
Digital Inputs (1-4) ..................
Relays (1 and 2) .....................
Locked ...................................
Unlocked ................................
Enet Act (Ethernet Activity) ....
Enet Spd (Ethernet Speed) ....
Enet Lnk (Ethernet Link) ........

INSTALLATION INFORMATION

Accessories

CAUTION: The IXP20 Controller needs a standard Ethernet cable to connect to
a PC. We do NOT however supply this cable with the Controller's
accessories.
Find the following when unpacking the ImproX IXP20 Controller:

Either an ImproX IXP20 Twin Reader Controller with Web Interface (ISC920)
supplied in a Black ABS Plastic housing. The housing consists of a Front Cover
Assembly and a Mounting Plate. The Front Cover and Mounting Plate are held
together with two Combi Screws (M4 x 10 mm) at the bottom of the housing.

There are also two spare Combi Screws (M4 x 10 mm).

Or, an ImproX IXP20 Twin Reader Controller with Touch Screen (ISC921)
supplied in a Black ABS Plastic housing. The housing consists of a Front Cover
Assembly and a Mounting Plate. The Front Cover and Mounting Plate are held
together with two Combi Screws (M4 x 10 mm) at the bottom of the housing.

There are also two spare Combi Screws (M4 x 10 mm).
CAUTION: DO NOT use the Metal-oxide Varistors (25 Vrms, 500 A, 77 V max
clamping) with mains power applications.

Three Metal-Oxide Varistors, 25 Vrms, 500 A, 77 V max clamping.

A 3 V, CR2032, Lithium cell Battery.
ISC304-0-0-GB-06
Thin Film Transistor Liquid Crystal Display
(TFT-LCD).
240 x 320 Pixels.
65 K Colour Screen.
Permanently on.
Continuous Red.
Flashing Red.
Flashing Green LED.
Flashing Red LED.
Continuous Green on detected contact
closure.
Continuous Red on activation of the Relay.
Continuous Green when locked.
Continuous Green when unlocked.
Flashing Red LED.
Continuous Red for 100 Mbps (Default)
Off for 10 Mbps.
Continuous Red on connection to network.
April 2011 Page 4