Advertisement
Controller Interfaces
Status LED .............................
Antenna Reader Interfaces
Status Indicator
Status LED .....................
Buzzer
Volume and Tone ...........
INSTALLATION INFORMATION
Accessories
Find the following when unpacking the ImproX IXP110 Controller:
An IXP110 Controller housed in a Black, Aluminium extruded Cabinet. The
Cabinet consists of a Top Cover, a Base and two End Plates. Each End Plate is
attached with four Thread Cutter Screws (2.2 x 5 mm).
One copy of IXP110 Software on CD.
A 3 V Lithium Battery (CR2032).
CAUTION:
DO NOT use the Metal-oxide Varistors (25 Vrms, 500 A, 77 V max
clamping) with mains power applications.
Two Metal-Oxide Varistors, 25 Vrms, 500 A, 77 V max clamping.
Four Wood Screws (3.5 mm x 25 mm).
Four Wall Plugs (7 mm).
IXP905-1-0-GB-XX includes a standard 2 m (7 ft) USB Printer Cable. The USB
Cable will have a Type 'A' plug fitted at one end and a Type 'B' plug fitted at the
other end.
IXP906-1-0-GB-XX includes a MAC Address Label.
An extra Fixed Address Label.
General
Remember the following when installing your IXP110 Controller:
Communications Distance
The Ethernet version of the Controller plugs into an Ethernet Switch or Hub (or
other network device), cable runs for this must conform to ethernet cabling
specifications.
The RS232 communications distance between the IXP110 Controller and the
connected Host PC MUST NOT exceed 25 m (82 ft). Achieve this by using good
quality screened 4-core cable.
The USB communications distance between the Host PC and the IXP110
Controller MUST NOT exceed 5 m (16 ft). Please note, however, the SUPPLIED
CABLE CANNOT BE EXTENDED.
IXP343-0-0-GB-07
Green LED (externally visible).
Bi-colour, Red or Green LED.
4-Step adjustable volume, single tone.
April 2009
Page 3
Advertisement
