Table of Contents
Advertisement
General precautions
During transport of the gauge the motor block
should be locked.
This is for protection of the weighing system.
The box in which the 854 arrives also contains
the measuring drum.
This is a precision measuring device and shall only
be installed by a qualified commissioning engineer.
Accurate measurement requires an undamaged
Special tools
Screw driver for Hex Allen-key screws M4 (length min. 22 mm) Part No.: 2998.506
Tommy bar
Caution
Caution
and clean drum.
Installation guide 854 ATG
General precautions
Figure 1
Motor(un)locking
Part No.: 2998.026
Page 5
Hide quick links:
Advertisement
Table of Contents
