Switching The Warning Tone; Switching The Auxiliary Setting; Switching The Dimmer Setting; Setting The Rear Output And Subwoofer Controller - Pioneer Premier DEH-P490IB Operation Manual

Section
02 Operating this unit
3 Press a or b to set the date and clock.
Pressing a will increase the value of the se-
lected segment. Pressing b will decrease the
value of the selected segment.

Switching the warning tone

If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press FUNCTION to select
WARNING TONE.
2 Press a or b to turn WARNING TONE
on or off.

Switching the auxiliary setting

Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on the next page.
1 Press FUNCTION to select AUX1/AUX2.
2 Press a or b to turn AUX1/AUX2 on or
off.

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can turn the dimmer on or off.
1 Press FUNCTION to select DIMMER.
2 Press a or b to turn DIMMER on or off.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP FULL) or subwoofer
22
En
(REAR SP S/W) connection. If you switch the
rear output setting to REAR SP S/W, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
1 Press FUNCTION to select
S/W CONTROL.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
REAR SP FULL (full-range speaker) and
REAR SP S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select REAR SP FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer REAR SP S/W.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
19).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.

Switching the feature demo

The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1 Press FUNCTION to select
DEMONSTRATION.
2 Press a or b to turn DEMONSTRATION
on or off.
Notes
! Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.