To Raise Or Lower Platform Using Platform Control Console; To Drive Forward Or Backward - Skyjack 7127 Operating Manual

Section 2 - Operation
2.10-4 To Raise or Lower Platform Using
Platform Control Console
wARNiNG
Be aware of overhead obstructions or
other possible hazards around the aerial
platform when lifting.
wARNiNG
Do not lower the platform unless the
area below is clear of personnel and
obstructions.
1. Activate platform control console (refer to
Section 2.10-3).
2. Press and hold "
select and hold raise/off/lower switch to either
" " raise or " " lower position. Release switch
to stop.
wARNiNG
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
NOTE
If the tilt alarm sounds and the platform does
not, or only partially raises, immediately
lower the platform completely and ensure
that the aerial platform is on a firm level
surface.
NOTE
Some models may be equipped with
lift cut out at 8 m. To raise the platform
higher, outriggers must support the aerial
platform.
SKYJACK, Page 42
" enable pushbutton, then
February 2008

2.10-5 To Drive Forward or Backward

wARNiNG
Be aware of blind spots when operating
the aerial platform.
wARNiNG
Ensure that there are no personnel
or obstructions in the path of travel,
including blind spots.
1. Activate platform control console (refer to
Section 2.10-3).
2. On platform control console, select off/lift/drive
key switch to " " drive position.
3. Activate and hold "
4. Push or pull controller handle forward or backward
to desired speed and direction of platform
travel.
5. Return controller handle to neutral center position
to stop. Release " " enable trigger switch.
wARNiNG
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
Start Operation
" enable trigger switch.
Mid Size & Full Size RT's
Engine Powered