To Activate Platform Control Console; To Raise Or Lower Platform Using Platform Control Console; To Drive Forward Or Backward - Skyjack SJ12 Operating Manual

Start Operation
2.9-3

To Activate Platform Control Console

1. Turn main power disconnect switch to " "on
position.
2. On base control console, pull out "
stop button.
3. Select base/off/platform key switch to "
platform position.
wARNiNG
Ensure that you maintain three points of
contact to mount/dismount platform.
4. Open the gate and access the platform.
5. Close the gate.
6. On platform control console, pull out "
emergency stop button.
2.9-4 To Raise or Lower Platform Using
Platform Control Console
wARNiNG
Be aware of overhead obstructions or
other possible hazards around the aerial
platform when lifting.
wARNiNG
Do not lower the platform unless the area
below is clear of personnel and
obstructions.
1. On platform control console, select lift/off/drive
switch to " " lift position.
2. Activate and hold "
3. Move controller handle forward or backward until
desired height is reached.
TM
Page 36
" emergency
" enable trigger switch.
December 2007
4. Return controller to neutral center position to stop.
Release " " enable trigger switch.
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
"
If the tilt alarm sounds and the platform does
not, or only partially raises, immediately
lower the platform completely and ensure
that the aerial platform is on a firm level
2.9-5

To Drive Forward or Backward

"
Be aware of blind spots when operating
the aerial platform.
Ensure that there are no personnel
or obstructions in the path of travel,
including blind spots.
1. On platform control console, select lift/off/drive
switch to drive "
2. Activate and hold "
3. Move controller handle "
" " backward/down to desired speed and
direction of aerial platform travel.
4. Return controller to neutral center position to stop.
Release " " enable trigger switch.
To protect against unintended movement of
the aerial platform, push in the emergency
stop button after you have arrived at your
desired location or elevation.
Section 2 - Operation
wARNiNG
NOTE
surface.
wARNiNG
wARNiNG
" position.
" enable trigger switch.
" forward/up or
wARNiNG
Vertical Mast Series