Error Messages - Excell PCH3 User Manual

EXCELL PRECISION CO., LTD.
:
:
:
:
: Totalizing the quantity or weight.
: Clear the stored totalizing memory. Or shift the digit pointer to right.
ON/OFF : Turn on or turn off the scale.

1-5 Error Messages

 zero value is too high (OMIL or NTEP ＞10% full scale)
 zero value is too low (OMIL or NTEP ＜10% full scale)
 Internal value ＞700,000 (use in factory calibration)
 Internal value ＜100,000 (use in factory calibration)
 The weight value is over 9d of the maximum capacity. (d = division)
 Internal value is unstable (Unstable time is over 10 seconds after pressing
03004035
Press this key, the display returns to 0.
Press this key to deduct the weight of container. Or shift the digit pointer to left.
Press this key to preset the unit weight of sample. Or use this key to enter the
setting mode.
Pre-setting the upper limit of count. If the calculated count is larger than the
limit, the scale sends a warning sound. Or use this key to confirm the setting.
or key)
Z T
8 ZSME200000058