Skoda Rapid Operating Instructions Manual page 134

Do not attach any stickers to the filaments or glass antenna - there is risk of
■
damage.
Do not clean the roof panelling with a brush – risk of damage to the surface
■
of the panelling.
Cleaners containing solvents can damage the material being cleaned.
■
Apply only a small amount of the cleaning and care product.
■
For the sake of the environment
Used vehicle care product cans represent hazardous waste that is harmful to
the environment. These must be disposed of in accordance with national legal
regulations.
Note
Due to the special tools and knowledge required, and to avoid any potential
problems with the cleaning and care of the interior of your vehicle, we recom-
mend that cleaning and care of the interior of your vehicle be carried out by a
ŠKODA service partner.
Natural leather

Read and observe and
The leather needs, depending on the strain placed on it, regular cleaning and
maintenance.
Dust and dirt in pores and creases cause abrasions on the surface and lead to
premature embrittlement of the leather surface. Therefore, they must be re-
moved regularly at short intervals with a cloth or vacuum cleaner.
Clean soiled leather surfaces with a water-dampened cotton or woollen cloth
and then dry with a clean, dry cloth
Clean severely soiled areas with a cloth soaked in a mild soap solution (2 ta-
blespoons of neutral soap to 1 litre of water).
To remove stains, use a cleaning agent specially designed for this purpose.
Treat the leather periodically with a suitable leather protector and use a skin
care cream with light blocker and impregnation after each cleaning.
on page 130 first.
» .
CAUTION
Ensure that no part of the leather is soaked through during cleaning and that
■
no water gets into the seams. Otherwise, the leather could become brittle or
cracked.
Avoid leaving the vehicle for lengthy periods in bright sunlight to prevent the
■
leather from bleaching. If the vehicle is parked in the open for lengthy periods,
protect the leather from direct sunlight by covering it.
The use of an additional mechanical steering wheel lock may damage the
■
leather surface of the steering wheel.
Some clothing materials, e.g. dark denim, do not have sufficient colour fast-
■
ness. This can cause damage or clearly visible discolouration to seat covers,
even when used correctly. This applies particularly to light-coloured seat cov-
ers. This does not relate to a fault in the seat cover, but rather to poor colour
fastness of the clothing textiles.
Sharp-edged objects on items of clothing such as zip fasteners, rivets, sharp-
■
edged belts etc. may leave permanent scratches or signs of rubbing on the
surface or damage these. Such damage cannot be subsequently recognised as
a justified complaint.
Note
When using the vehicle, minor visible changes may occur to the leather parts
of the covers (e.g. wrinkles or creases) as a result of the stress applied to the
covers.
Artificial leather, materials and Alcantara

Read and observe and
Artificial leather
Clean artificial leather with a damp cloth.
If this method does not completely clean the artificial leather, use a mild soap
solution or cleaning products specially designed for this purpose.
Fabric
Clean upholstery cover materials and cloth trims on doors, boot cover, etc. us-
ing specific cleaning agents, e.g., dry foam.
Use a soft sponge, brush, or commercially available microfibre cloth.
Use a cloth and a cleaning agent specifically designed for this purpose to clean
the roof trim.
Remove any lumps on the cover fabric and any fabric residue using a brush.
®
on page 130 first.
Care and maintenance

131