Installing The Configuration Utility For Windows Nt - Linksys WPC11 User Manual

7. The Network PC Card has
now been installed. You will
see it added onto the screen
shown in Figure 6-24. Click
the Close button to continue
and then restart your comput-
er.
8. Once the drivers have
been installed, the fol-
lowing screen (Figure
6-25) may appear.
29
Instant Wireless Series
TM
Figure 6-24
Figure 6-25
Network PC Card
If the screen shown in Figure 4-25 appears, make sure that the Instant Wireless
Network PC Card ver. 3.0 appears in the Adapter window. Then, unless you
need to assign a static IP address, select Obtain an IP address from a DHCP
server and click the OK button. If you need to assign a static IP address, select
Specify an IP Address, and enter the appropriate values under IP Address,
Gateway Mask, and Default Gateway. After you have made your choice,
click the OK button.
Windows NT has now completed installing the drivers. Remove the Setup
Utility CD from the CD-ROM drive and click the Finish button to continue.
Then, restart your computer.
NOTE: After you have installed the Network PC Card,
reapply the Windows NT service pack.
The Driver Installation is complete. Continue now to the section called

Installing the Configuration Utility for Windows NT.

Installing the Configuration Utility for Windows NT
Once you have restarted your computer, the drivers for the Card should load suc-
cessfully. Now it is necessary to install the Configuration Utility. Insert the Setup
Utility CD in the CD-ROM drive. Unless you have deactivated the auto-run fea-
ture of Windows, the screen shown in Figure 6-26 should appear automatically.
Figure 6-26
30