Linksys WPC11 User Manual page 16

17. On the screen shown in Figure 6-15, enter your Computer Name, how your
computer is identified on the network. Then, assign the computer to either
a Workgroup or Domain, whichever is appropriate. The Computer Name
must be differ-
ent than any
other on the
Workgroup or
Domain. Click
the Next but-
ton.
18. Once the drivers
have been installed,
the following screen
(Figure 6-17) may
appear.
25
Instant Wireless Series
TM
Figure 6-16
Figure 6-17
Network PC Card
Make sure that the Instant Wireless Network PC Card ver. 3.0 appears in the
Adapter window (as shown in Figure 6-17). Then, unless you need to
assign a static IP address, select Obtain an IP address from a DHCP
server and click the OK button. If you need to assign a static IP address,
select Specify an IP Address, and enter the appropriate values under IP
Address, Gateway Mask, and Default Gateway. After you have made your
choice, click the OK button.
Windows NT has now completed installing the network. Remove the Setup
Utility CD from the CD-ROM drive and click the Finish button to contin-
ue. Then, restart your computer.
The Driver Installation is complete. Continue now to the section called
Installing the Configuration Utility for Windows NT.
Note: After you have installed the Network PC
Card, reapply the Windows NT service pack.
If You Have Installed Network Hardware Before:
1. Windows NT is not a
Plug-and-Play Operating
System and will not
automatically identify
the Network PC Card. To
begin setup, insert the
Setup Utility CD into
your CD-ROM drive and
then select Settings from
the Start Menu. Bring
up the Control Panel (as
shown in Figure 6-18)
and double-click the
Network icon.
Figure 6-18
26