Ad-Hoc Mode - Linksys WPC11 User Manual

Ad-Hoc Mode

1. If you have chosen Ad-Hoc mode, the following screen will appear. (See
Figure 2-13.) If you have chosen Infrastructure mode, refer to the previ-
ous section, titled "Infrastructure Mode".
You will be prompted to choose a Channel from the list provided.
computers on your wireless network must be using the same channel in
order to communicate with each other. If you are unsure about which chan-
nel to use, select the default channel (Channel 6). Once you have chosen
your channel, click the Next button.
11
Instant Wireless
Figure 2-13
Series Network PC Card
TM
2. The screen shown in Figure 2-14 should appear. You will be prompted to
enter an SSID value in the field provided. All SSID values on your wire-
less network must match. If you are unsure, use the default value of
"linksys." Then, click the Next button.
3. The next screen to appear (Figure 2-15) will be the Review Settings screen.
Verify that all the settings are correct and click the Next button to contin-
All
ue.
Figure 2-14
Figure 2-15
12