Section
Initial Settings
08
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1
display
FUNCTION
Shows the function status.
1 Press
SOURCE
off.
2 Press
FUNCTION
appears in the display.
3 Press
FUNCTION
settings.
Press
FUNCTION
the following settings:
—
—
CLOCK
FM
DAB
—
—
DIM
BRIGHT
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down
FUNCTION
Setting the time
This is used to set the time on the unit's clock
display.
1 Press
FUNCTION
Press
FUNCTION
display.
36
En
1
and hold until the unit turns
and hold until time
to select one of the initial
repeatedly to switch between
—
—
—
A-PI
WARN
AUX
—
—
—
ILL
SW
TEL1
TEL2
BAND/ESC
until the unit turns off.
to select the
CLOCK
until the time appears in the
2 Select the portion of the time display you
wish to set with 2/3.
Pressing 2/3 will select a portion of the clock
display:
—
HOUR
MINUTE
As you select portions of the clock display the
portion selected will blink.
3 Select the correct time with 5/∞.
Pressing 5 will increase the selected hour or
minute. Pressing ∞ will decrease the selected
hour or minute.
Setting the FM tuning step
Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA is on the tuning
step automatically changes to 100 kHz. It may
—
be preferable to set the tuning step to 50 kHz
when AF is on.
1 Press
FUNCTION
.
Press
FUNCTION
appears in the display.
2 Select the FM tuning step with 2/3.
Pressing 2/3 will switch the FM tuning step
between 50 kHz and 100 kHz while AF or TA is
on. The selected FM tuning step will appear in
the display.
Note
.
• The tuning step remains at 50 kHz during
manual tuning.
to select FM.
repeatedly until
FM Step