Switching The Dimmer Setting; Selecting The Brightness; Selecting The Illumination Color; Setting The Rear Output And Subwoofer Controller - Pioneer KEH-P7020R Operation Manual

Section
Initial Settings
08

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can switch dimmer on or off.
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
on or off with 5/∞.
2 Select
DIM
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
).
Dimmer :ON

Selecting the brightness

You can select the display brightness. Initially
this mode is set to 12.
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
2 Select the desired brightness with 2/3.
• The display shows

Selecting the illumination color

This product is equipped with two illumination
colors, green and red.
You can select the desired illumination color.
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
2 Select the desired illumination color with
2/3.
Pressing 2/3 will switch
or green and that status will be displayed (e.g.,
).
ILLUMI :GRN
38
En
to select .
DIM
repeatedly until
Dimmer
between on
Dimmer
to select .
BRIGHT
repeatedly until
Brightness
– .
0 15
to select .
ILL
repeatedly until
ILLUMI
between red
ILLUMI
Setting the rear output and sub-
woofer controller
This product's rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (
Rear SP:FULL
( ) connection. If you switch rear
Rear SP:S.W
output setting to the
Rear SP:S.W
nect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
When rear output are connected to full range
speakers (when
Rear SP:FULL
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller's (low pass
filter, phase) built-in
S.W Control:INT
auxiliary
S.W Control:EXT
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 34) or subwoofer output
(refer to page 33) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
2 Change the rear output setting with 5/∞.
Pressing 5/∞ will switch between
(full-range speaker) and
:FULL
(subwoofer) and that status will be displayed.
) or subwoofer
, you can con-
).
is selected), you
or the
.
.
SW
Rear SP
Rear SP
Rear SP :S.W