F:\#Work#\Y3\eV\Harrier 7\Sagyo data\4573332111\4573332111XAVV750BTE17\01GB-
010book.book Page 26 Tuesday, November 24, 2015 9:51 AM
The name of the detected device does not
Depending on the status of the other device, it
may not be possible to obtain the name.
There is no ringtone.
Raise the volume while receiving a call.
The talker's voice volume is low.
Raise the volume during a call.
The other party says that the volume is too low
Adjust the [MIC Gain] level (page 14).
Echo or noise occurs during call conversations.
Reduce the volume.
If ambient noise other than the phone call sound
is loud, try reducing this noise.
Shut the window if road noise is loud.
Lower the air conditioner if the air conditioner
The phone sound quality is poor.
Phone sound quality depends on reception
conditions of the cellular phone.
Move your car to a place where you can
enhance the cellular phone's signal if the
reception is poor.
The volume of the connected BLUETOOTH device
is low or high.
Volume level will differ depending on the
Reduce the volume level differences between
this unit and the BLUETOOTH device (page 12).
The sound skips during audio streaming or the
BLUETOOTH connection fails.
Reduce the distance between the unit and the
If the BLUETOOTH device is stored in a case which
interrupts the signal, remove the case while
using the device.
Several BLUETOOTH devices or other devices (e.g.
ham radio devices) which emit radio waves are
Turn off the other devices.
Increase the distance between the unit and
Playback sound stops momentarily when this
unit is connecting to a cellular phone. This is not
You cannot control the connected BLUETOOTH
device during audio streaming.
Check that the connected BLUETOOTH device
Some functions do not work.
Check that the connecting device supports the
functions in question.
A call is answered unintentionally.
The connecting phone is set to start a call
[Auto Answer] of this unit is set to [ON] (page 14).
Pairing failed due to time out.
Depending on the connecting device, the time
limit for pairing may be short. Try completing the
pairing within the time by setting a single digit
The BLUETOOTH function cannot be operated.
Exit the source by pressing and holding SOURCE
for 1 second, then turn on the unit.
No sound is output from the car speakers during
a handsfree call.
If the sound is output from the cellular phone, set
the cellular phone to output the sound from the
Siri Eyes Free is not activated.
Perform the handsfree registration for an iPhone
that supports Siri Eyes Free.
Set the Siri function on the iPhone to on.
Cancel the BLUETOOTH connection with the
iPhone and the unit, and reconnect.
Application name is mismatched with the actual
application in "SongPal."
Launch the application again from the "SongPal"
Hubs not supported.
USB hubs are not supported on this unit.
No Playable Data
The iPod has no playable data.
Load music data/files into the iPod.
The USB device has no playable data.
Load music data/files into the USB device.
Cannot play this content.
The currently selected content cannot be played
Playback content will be skipped to the next