F:\#Work#\Y3\eV\Harrier 7\Sagyo data\4573332111\4573332111XAVV750BTE17\01GB-
010book.book Page 32 Tuesday, November 24, 2015 9:51 AM
Mounting the unit in the dashboard
For Japanese cars, see "Mounting the unit in a
Japanese car" (page 32).
Mounting the unit with an installation kit
Before installing, make sure the catches on both
sides of the bracket are bent inwards 3.5 mm (
Position the bracket inside the
dashboard, then bend the claws outward
for a tight fit.
111 mm (4
Mount the unit onto the bracket.
If the catches are straight or bent outwards, the unit will
not be installed securely and may spring out.
Mounting the unit in a Japanese car
You may not be able to install this unit in some
Japanese cars. In such a case, consult your Sony
When mounting this unit to the preinstalled
brackets of your car, use the supplied screws in
the appropriate screw holes based on your car:
T for TOYOTA, M for MITSUBISHI and N for NISSAN.
182 mm (7
To prevent a malfunction, install only with the supplied
Resetting the unit
For details, see "Resetting the Unit" (page 7).
When replacing the fuse, be sure to
use one matching the amperage
rating stated on the original fuse. If
the fuse blows, check the power
connection and replace the fuse. If
the fuse blows again after
replacement, there may be an
internal malfunction. In such a case, consult your
nearest Sony dealer.
To the dashboard/center console
Parts supplied with
Fuse (10 A)