Table Top Installation - Regency Plateau Owners And Installation Manual

installation
|
16

TABLE TOP INSTALLATION

Stainless must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
To protect the finish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even when removing
protective coating).
Stainless will discolor slightly during normal operation. This is normal and should not be considered a defect.
All hand and finger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a film/residue on
the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this film before applying heat to the unit. Failure to do this
may result in burn stains which you will be unable to remove. This is not a warranty item.
1. Place table top on unit.
OPTIONAL THERMOCOUPLE SHIELD INSTALLATION
For areas with high wind velocity - the supplied thermocouple shield
should be installed, to prevent nuisance outages.
1. Install shield over thermocouple with one screw as shown.
16 |
Regency PTO28-1 City Table Outdoor Gas Fireplace
Diagram 1
Thermocouple shield
Before you start:
2. Secure each corner with the bolt/nutsert.
Diagram 2
3. Reverse steps to remove.
Secure each corner with a bolt.