Lp Hard Line Conversion(For Use In Place Of Lp Tank) - Regency Plateau Owners And Installation Manual

installation
|
12
LP HARD LINE CONVERSION
(FOR USE IN PLACE OF LP TANK)
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
Each Kit contains one LP Hard Line Conversion Kit
Conversion Kit Contains:
Qty. Part #
1 909-265
1 286-035
1 286-036
1 911-136 Regulator LP
1 904-978
4 904-553
1 919-334 Instruction sheet
Turn off unit and allow to cool to room temperature.
1. Remove panel (180º to the right of the ON/OFF knob. Lift panel up slightly
by handle and pull outwards. Place panel on a soft clean surface.
Handle
Remove this
panel
2. Remove LP tank and LP hose from valve.
12 |
Regency PTO28-1 City Table Outdoor Gas Fireplace
919-334
LP HARD LINE CONVERSION
IF IN DOUBT DO NOT DO THIS CONVERSION !!
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Description
Max 0.5 psi label
Regulator mounting base
Regulator mounting top
3/8" fl ex pipe 18" length
#8 Phillips
Diagram 1
Diagram 2
PLATEAU / KEY WEST SERIES
3. Install regulator bracket onto unit base with 2 screws. Connect fl ex line to
regulator—position regulator onto bracket.
Switch
Side
Regulator
Regulator
Bracket
4. Secure regulator in position with top bracket - secure with 2 screws.
NOTE: Top bracket to sit over top of lower bracket.
Attach supplied "MAX. 0.5 PSI" sticker to top bracket.
LP hose
Top
Bracket
1
Location to install
Access for
regulator
Hard line
Diagram 3
Diagram 4
Diagram 5
12/17/13