Lp Tank Gas Connection - Regency Plateau Owners And Installation Manual

LP TANK GAS CONNECTION

1. Remove panel (180º to the right of the ON/OFF knob. Lift panel up slightly
by handle and pull outwards. Place panel on a soft clean surface.
Handle
Remove this
panel
2. Loosen butterfly bolt to allow LP tank to be seated on the holder - seat tank
and tighten butterfly bolt.
Butterfly Bolt
Diagram 1
Diagram 2
Tank Holder
3. Connect gas line to LP tank
Switch
Side
4. Check all gas connections under normal operating pressure, for leaks,
with soapy water.
NOTE: If soap bubbles, this would indicate a gas leak.
5. Reverse step 1.
Average LP Tank Burn Times
20lb Tank
NOTE: Inspect hose before each use of appliance.
Regency PTO28-1 City Table Outdoor Gas Fireplace
installation
Diagram 3
High
13 Hrs
|
11
| 11