Connecting Power; Installing And Removing Ops Module - BenQ RP553K User Manual

Connecting power

Plug one end of the power cord into the Power-in jack on the display and the other end
into an appropriate power outlet (if the outlet is switched, turn on the switch).
• The supplied power cord is suitable for use with 110-240V AC power only.
• The power cord and outlet illustrated may differ from the ones used in your region.
• Only use an appropriate power cord for your region. Never use a power cord which appears
damaged or frayed, or change the plug type on the power cord.
• Be aware of the power loading when you use extension cords or multiple outlet power boards.
• There are no user serviceable parts in this display. Never unscrew or remove any covers.
There are dangerous voltages inside the display. Turn off the power and unplug the power cord
if you intend to move the display.

Installing and Removing OPS module

The illustration shown below is for your reference. The actual content, pre-installed
applications and available services may vary by the product supplied for your region. OPS
module should be purchased separately.
To install the OPS module:
1. Power off the display.
2. Remove the two screws to remove the OPS cover.
3. Insert the OPS module and then secure with screws.
Keep the OPS cover for future use.
To remove the OPS module:
1. Power off the display.
2. Remove the two screws and pull out the OPS module.
Connection 19