Basic Operations; Turning The Display On Or Off; Initial Setup - BenQ RP553K User Manual

Basic operations

Turning the display on or off

Before turning on the display, make sure the power switch is set
to ON (I). The system will enter standby mode.
• To turn on the display, press the POWER
button on the control panel or on the remote
control.
• To turn off the display, press the POWER
button on the control panel or on the remote
control. The system will automatically enter
standby mode.
The display's standby mode still consumes power. To completely cut off power supply, set the
power switch to OFF (O) and then disconnect the power cord from the power outlet.

Initial Setup

After you have connected the display to the power, you are ready to power on the
display. The first time you power on the display, you will be guided through a series of
setup screens. Follow the on-screen instructions or the steps below to start up your
display and complete the initial setup.
1. Turn on the display. Wait for the display to boot up with the BenQ screen. This may
take a moment.
2. Tap Next on the screen to begin. Follow the on-screen instructions to set up the
language, date and time, and network. Or your can skip some of these steps and
complete the setup later.
Basic operations
IR Receiver
Power Button
25