Positioning And Installation - Grimac TWENTY Series PUL 2 Operating And Maintenance Instructions Manual

1.3 - POSITIONING AND INSTALLATION

After checking that the machine is complete, locate it in the position in which it will be used. Ensure that the position is stable and safe and allows
enough space for carrying out the different operations (fitting the filter holder, obtaining hot water and steam).
The following appliances must be installed, adjusted and connected to the mains water and electric power supplies by qualified people in strict
compliance with the instructions contained in this manual.
To ensure that the machine works correctly and remains in proper working order, read this manual carefully, adhere to the standards which it sets out
and refer to the diagrams it contains.
Place the machine on a flat surface that is out of the reach of children.
To prevent the machine's being knocked, do not locate it in places where there is a lot of movement to and from or in narrow corridors.
Connecting to mains power supply
Connect the power cable to the mains by means of a 24 amp fused switch as shown on the label on the cable.
.
Connecting to the mains water supply
1 - cold water must be supplied to the machine;
2 - check that mains water supply pressure is compatible with the technical specifications for the machine;
3 - connect the drain pipe to the tank underneath the drip tray and do not make tight bends;
4 - connect the 3/8" hose to the mains supply;
5 - ensure that there is an adequate inclination to enable water to drain away;
6 - if the mains supply water is to be treated with a water softener, follow the instructions set out on page 50.
39