Winter Hibernation; Replacing The Battery - Worx Landroid WR101SI Instruction Manual

• Battery maintenance during storage
®
Landroid can be charged manually without the boundary wire.
To manually charge the battery without connecting the boundary wire to the Charging Base;
1. Connect the Charging Base to a suitable power supply. The Charging Base green light will turn on.
2. Manually dock the Landroid
3. The Charging Base green light will turn to red, and the battery indication light will flash green. (See
Fig. P2) Landroid
P1

9.4 Winter hibernation

®
Your Landroid will live longer and healthier if it is allowed to hibernate. So even though it is tough, we would recommend
that you store your Landroid
Before you prepare your Landroid
• Thoroughly clean your Landroid
• Fully charge the battery
16
• Turn the power off
To maximize the battery life, it is recommended to fully charge the battery before storage during winter.
WARNING: Protect the underside of Landroid
outdoors in case of water inflowing.
The Boundary Wire can be left in the ground although its ends should be protected, such as placed in a tin can with grease.
If the Charging Base is left outside for winter, leave the Boundary Wire connected.
NOTE: When bringing the Landroid
Pins (2) are clean, it is recommended to use a fine grade emery cloth to clean. Then make sure the date and time are
correct and send the Landroid

9.5 Replacing the battery

WARNING: Turn power off before attempting any adjustment, replacement or repair.
If you need to replace the Battery, follow these steps:
Q1
Lawn Mowing Robot
®
into the Charging Base while the Landroid
®
will begin to charge.
®
in your shed or garage during the winter.
®
for winter hibernation, we recommend you:
®
®
back to work after winter hibernation, make sure the Charging Strips (4) and Contact
®
back to what it loves doing: mowing.
®
is powered off. (See Fig. P1)
P2
®
from water. NEVER store Landroid
Q2
®
upside down
a
EN