Lionel Pirate Ship Ride Owner's Manual
Lionel Pirate Ship Ride Owner's Manual

Lionel Pirate Ship Ride Owner's Manual

Advertisement

71-4171-250
9/02
Lionel
Pirate Ship Ride
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pirate Ship Ride and is the answer not in the manual?

Questions and answers

Summary of Contents for Lionel Pirate Ship Ride

  • Page 1 71-4171-250 9/02 Lionel Pirate Ship Ride Owner’s Manual...
  • Page 2: Table Of Contents

    Accessory Switch Controller wiring and operation Notes Limited Warranty/Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel®, TrainMaster®, Odyssey®, RailSounds™, CrewTalk™, TowerCom™, DynaChuff™, StationSounds™, Pullmor®, ElectroCoupler™, Magne-Traction®, CAB-1 Remote Controller®,...
  • Page 3: Wiring The Pirate Ship For Conventional (Non-Command) Operation

    Pirate Ship accessory with a separate accessory power supply or through track power with a Lionel Lock-On. This accessory operates best at 12-18 volts (AC). You need the ends of the wires to be stripped back 1/4” to 3/8”. To strip the wires, Caution! use a pair of wire strippers or a sharp knife.
  • Page 4: Turning The Accessory On And Off

    Turning the accessory on and off he ON/OFF switch has been hidden on the rocky base of the accessory. Refer to Figure 2 to locate the switch. Slide the rocky outcropping towards the right to turn on the accessory, or to the left to turn it off.
  • Page 5: Operating Your Pirate Ship With Trainmaster Command Control

    Operating your Pirate Ship with TrainMaster Command Control ire your accessory with an SC-2 Switch and Accessory Controller (available separately, 6-22980) or the Accessory Switch Controller (available separately, 6-14182). Refer to these manuals for additional information. Be sure that the ON/OFF switch is in the ON position. Refer to Figure 2 on page 4 for Note! the location of that switch.
  • Page 6: Accessory Switch Controller Wiring And Operation

    Operating your Pirate Ship with TrainMaster Command Control (continued) Accessory Switch Controller wiring and operation Three wires (not included) are needed to connect your Pirate Ship to the Accessory Switch Controller (ASC) and a separate accessory transformer. 1. Attach one wire to the transformer Power/A terminal and connect it to the COMM terminal on the ASC.
  • Page 7: Notes

    Notes...
  • Page 8: Limited Warranty/Lionel Service

    Limited Warranty/Lionel Service his Lionel product, including all mechani- Your nearest Lionel Service Center can be found by cal and electrical components, moving calling 1-800-4-Lionel, or by accessing our Website parts, motors and structural components, at www.lionel.com. except for light bulbs, is warranted to the original...

Table of Contents