Table of Contents
Advertisement
28
en | Configuration
7.4
Wall Panel configuration
This section only describes the configuration of the Wall Panel. For information on connecting
and operating the Wall Panel, refer to:
–
–
3
Figure 7.3: Fig 8-5
Number Item
6
Level control
Not
2-pin jumper connector
shown
on
drawing
2014.09 | V1.2 |
Wall Panel connections, page 20
Wall Panel operation , page 40
2
1
5
4
Description
Used to adjust the output level for the Line and Microphone inputs on
the Wall Panel to the All-in-One Unit.
The Wall Panel has an internal 2-pin jumper connector to select
phantom power for the microphone connected to the XLR-connector. To
access the jumper, remove the front control panel as described in Install
Wall Panel, page 13.
–
Jumper connected: phantom power ON.
–
Jumper removed: phantom power OFF.
Installation and Operating Manual
7
8
6
Plena All-in-One System
Bosch Security Systems B.V.
Hide quick links:
Advertisement
Table of Contents
