Install Wall Panel - Bosch PLENA PLN-6AIO240 Installation And Operating Manual

Plena All-in-One System
5.3

Install Wall Panel

The Wall Panel consists of a flat control panel and a rear mounting bracket, which is used for
installing the product on a wall or flat surface. Cable entry is possible at the rear and sides of
the mounting bracket.
This allows the mounting bracket to be used for:
–
–
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems B.V.
solid masonry walls, where cables run externally across the wall and enter the product
from the side, or
frame constructions, where cables are inside the cavity and need to enter the product
from the rear.
Remove the four attachment screws on the control front panel to separate it from the
mounting bracket. Do not remove other screws from the mounting bracket. They are used
to secure components.
Gently remove the control panel from the mounting bracket and put it in a safe place.
Take care not to damage the printed circuit board on the back of the control panel.
Attach the mounting bracket to a flat surface:
– Make sure the RJ45 cable can easily enter the product.
– Make sure there are no electrical cables that will be damaged by the mounting
bracket attachment screws.
– Make sure the mounting bracket is level and straight before attaching it.
– Allow enough space around the mounting bracket so that the control panel can be
easily fitted.
Set the jumper on the rear of the control panel:
– Refer to Wall Panel configuration, page 28.
Feed the RJ45 cable through the mounting bracket and connect it to the RJ45 connector
at the rear of the control panel.
– To maximize the bend radius of the cable in the confined space it is strongly
recommended to use the shortest RJ45 connector possible.
– Make sure the All‑in‑One Unit is switched off before connecting the RJ45 cable.
– Refer to Wall Panel connections, page 20.
Gently position the control panel in the mounting bracket, taking care not to damage the
printed circuit board or the RJ45 cable.
Secure the control panel with the four attachment screws. Do not over-tighten.
Installation and Operating Manual
Installation | en 13
2014.09 | V1.2 |