Getting Started - Cochlear INERAID Owner's Handbook Manual

COMPONENTS
The major components of the INERAID artificial
ear are the implanted electrode assembly, the ear
hook assembly and the sound processor. The ear
hook is connected to the sound processor by a
cable. The cable has a break-away safety connecto r
which will d isconnect the sound processor from the
ear hook should the cable become entangled.
Sounds entering the microphone (which is
located in the ear hook) are changed to electrical
energy and conveyed through the cable to the
sound processor. The sound processing electronics
convert sounds into electrical stimuli which are sent
to the appropriate electrode implanted in the
cochlea. This info rmation is transmitted by the
auditory nerve to the brain.
GETTING STARTED
You have been shown how to connect the sound
processor to the ear hook and the percutaneous
pedestal. This guideline will help you remember
what you need to do. Inspect the different com-
ponents before connecting them together to make
sure everything is in order. Check to see that the
sound processor is turned off to prevent a sudden
noise when it is initially " plugged in."
Practice connecting the ear hook to the percu-
taneous pedestal until it feels comfortable. The
plastic prongs help guide the connector in the co r-
rect orientation. One of the pins is a small silver
guide pin which wil l allow the connector to go in
only one way. It should go together very easily. If
you have any problems have a friend help you.
You can damage the pedestal if you force the
connection.
NOTE: Do not attempt to insert the connector
if the pins are bent.
Al though you may be able to find an assembly
method that is easier for you, the following is
suggested.
1. Make sure the sound processor is OFF.
2. Connect the cable to the ear hook and fit the
hook over your ear.