Local Codes; Unpacking - Superior Fireplaces VRT4032ZMN Installation And Operation Instructions Manual

Radiant and louvered faced fireplace system with logs and thermostat blower
Table of Contents

Advertisement

Install and use fi rebox with care. Follow all
local codes. In the absence of local codes,
use the latest edition of The National Fuel Gas
Code ANS Z223.1/NFPA 54*. Firebox must
be electrically grounded in accordance with
the National Electrical Code, ANS/NFPA70
(latest edition).
NOTE: Where listed vented decorative logs
are required, thermostat operation is not
permitted.
COMMONWEALTH OF MASSACHUSETTS REQUIREMENTS
These appliances are approved for installation in the US state of Massachusetts if the fol-
lowing additional requirements are met:
• Un-vented Room Heaters shall be installed in accordance with 527 CMR 30.
• Installation and repair must be done by a plumber or gas fi tter licensed in the Common-
wealth of Massachusetts.
• The fl exible gas line connector used shall not exceed 36 inches (92 centimeters) in length.
• The individual manual shut-off must be a T-handle type valve.
• Unvented appliances may NOT be installed in bedrooms or bathrooms.
• A working smoke detector must be installed in the area where vent-free appliances are
installed.
Seller of unvented propane or natural gas-fi red supplemental room heaters shall provide
to each purchaser a copy of 527 CMR 30 upon sale of the unit.
CAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
1. With utility knife, cut the carton all the way
around above the staples on the bottom
tray. Lift the carton off the heater. Remove
packing.
NOTE: The hood is located in the packing
on the right hand side of the heater front.
Lift the heater off the bottom tray.
126868-01B

LOCAL CODES

*Available from:
American National Standards Institute, Inc.
National Fire Protection Association, Inc.

UNPACKING

2. Locate two screws above top corners of
the fi replace screen. Remove and discard
these screws. Push the bottom corners of
the screen in and release. The screen will
pop out at the bottom. Grasp the bottom
of the screen, lift the screen up and pull
out to remove.
3. Remove protective packaging applied to
logs, log base assembly, and fi replace.
4. Remove fireplace hood from carton
inserts.
5. Check all items for any shipping damage.
If damaged, promptly inform dealer where
you purchased the fi replace.
SuperiorFireplaces.us.com
25 West 43rd Street, 4th fl oor
New York, NY 10036
1 Batterymarch Park
Quincy, MA 02169-7471
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents