Superior Fireplaces VRT4032ZMN Installation And Operation Instructions Manual page 10

CHECK GAS TYPE
Use the correct gas type (natural or propane/
LP) for your fi replace. If your gas supply is not
correct, do not install fi replace. Call dealer
where you purchased fi replace for proper
type fi replace.
WARNING: This appliance is
equipped for natural or propane/
LP gas but not both. Gas type is
indicated on rating plate. Field
conversion is not permitted.
ELECTRICAL HOOKUP
This fi replace includes a blower which must
be connected to either a wall receptacle or
the electrical receptacle that is included within
the fi replace. If the receptacle included with
the fi replace is to be used, it must be wired
to a 120 volt supply by a certifi ed electrician.
INSTALLING HOOD
Install hood to rail already installed in fi replace
as shown in Figure 5. Use 3 Phillips screws
provided.
Rail
Hood
Screw
Figure 5 - Installing Hood
ASSEMBLING AND ATTACHING
OPTIONAL PERIMETER TRIM
IMPORTANT: If you are recessing the fi rebox
in a wall, do not attach trim at this time. See
Built-In Fireplace Installation, Page 12.
NOTE: These instructions show assembling
and attaching trim to fi replace.
1. Remove packaging from three pieces
of trim.
2. Locate four screws, two adjusting plates
with set screws, and two shims in the
hardware packet.
10
INSTALLATION
Continued
3. Align shim under adjusting plate as shown
in Figure 6.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top trim (see
Figure 6).
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side trim (see
Figure 6).
6. While firmly holding edges of trim to-
gether, tighten both set screws on the
adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
8. Tighten trim hanging screws (#10 x 6.25
shoulder) into holes in cabinets. Place
the assembled trim onto fi replace cabi-
net. Align hanging notches on trim with
hanging screws on side of fi replace (see
Figure 7). Push trim fi rmly into place, slid-
ing hanging notches over hanging screws.
Side Trim
Slot
Figure 6 - Assembling Perimeter Trim
Assembled
Trim
Figure 7 - Attaching Perimeter Trim to
SuperiorFireplaces.us.com
Set Screws
Adjusting
Plate
Mitered
Shim
Edge
Slot
Mitered
Edge
Trim
Hanging
Screws
Hanging
Notches
on Trim
Fireplace
126868-01B
Top
Trim