Superior Fireplaces VRT4032ZMN Installation And Operation Instructions Manual page 20

Radiant and louvered faced fireplace system with logs and thermostat blower
Table of Contents

Advertisement

11. Place the top rear log onto the rear log as
shown. The rear log has a projection that
will fi t into the recess area on the bottom
of the top rear log (see Figure 34).
Top Rear
Log
Rear Log
Figure 34 - Installing Top Rear Log
If replacement embers are needed,
the replacement embers must be
purchased from IHP - see Page 35
for part numbers.
WARNING: ALL PREVIOUSLY
APPLIED LOOSE MATERIAL
MUST BE REMOVED PRIOR TO
REAPPLICATION.
20
INSTALLATION
Continued
EMBER PLACEMENT
any other ember material not
supplied with this unit.
WARNING: Do not operate
unit without ember material
correctly in place as shown in
Figures 60 & 61. Do NOT place
ember material anywhere else
on the unit. Use only ember ma-
terial supplied with unit. Exces-
sive or incorrectly placed ember
material may produce carbon
monoxide or soot.
1. Ember Chunk Placement. The VRT4036
series burner systems include three em-
ber chunks that are designed to fi t over
shoulder screws on the ember pan burner.
The bottom of each ember chunk has a
hole for securing the ember chunk in place
when it is placed over a shoulder screw.
Place the ember chunks as shown in Fig-
ure 35 on Page 21 by placing the ember
chunk with the number "1" on the left, "2"
in the center, and "3" on the right. These
numbers are embossed on the back of
each piece for identifi cation purposes.
Please note that VRT4032 series burner
systems do not include ember chunks.
2. Two ember materials are supplied with
this log set. Platinum Bright Embers give
a bright glow appearing as hot coals.
Should embers need replacing, see
Parts, Page 33.
Platinum Bright Ember placement. Add
embers to front, fl at burner. Gently remove
embers from bag. Separate pieces of
ember material and place on surface of
fl at burner just behind horizontal ports as
shown in Figure 36.
Glowing embers (rockwool) placement.
Place glowing embers material on front
fl at burner in areas away from ports as
shown in Figure 37.
3. DO NOT place volcanic stone or addi-
tional logs on front burner or on logs.
Placing any material on unit other than
ember material on front burner may result
in production of carbon monoxide or soot.
SuperiorFireplaces.us.com
WARNING: Do not use
126868-01B

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents